Hard-wired tool setting probe for drill bit breakage detection and tool length measurement in small machining centres. Measurements of unrivalled speed and precision for micro-tools under the most adverse manufacturing conditions using a modern measuring mechanism based on a linear working principle and optoelectronic switch signal generation.
Z-Pico tool measuring probe – Measure and monitor the smallest tools at up to 2 m/min
Wear-free, optoelectronic signal generation
High-precision, modern measuring mechanism using linear working principle
BLUM tool measuring probes
Tool measuring probes by BLUM can be used for the most varied measurement and monitoring tasks in CNC machining centres.
Non-contact breakage detection of centric tools such as drills, mills, engraving tools, taps and reamers.
Automatic setting and wear monitoring of tools by quick and precise length measurement.
Compensation of tool wear using measurements between the machining steps. The wear value is stored as an additive correction value in the tool offset memory.
Compensation of the temperature-dependant thermal behaviour of machining centres.
Reliable and fast measurements in coolant thanks to modern measuring mechanism and robust design.
Ideally suited to mass production under the harshest conditions.
Tool setting probe Z-Pico
* Depending on geometry and material of tool. Probing force must not result in damage to tool.
Additional information can be found in the relevant brochure and in the operating manual.
BLUM measuring cycles
The measuring cycles are available for many conventional controls. Your local BLUM-representative will gladly inform you about the range of features for your control.
We have become more accurate thanks to the Blum measuring systems. This has meant that the impression which surgeons gain of the instruments quality has once again improved somewhat.